The model 9H Berkel slicer had been produced since 1936 and distributed ’till 1969. It’s about afywheel slicer with contained dimensions which shows mechanical aspects and slicing efficiency equal to the most sophisticated models. In fact,in all the Berkel 9H series, the slicing synchronism is similar to versions 5 and 7. Yet, the components were improved and optimized at the point that Berkel decided to use them ‘till the 60s during all the successive production. With Berkel Model 9H manual slicer we shift from the worm screw with ribbed clamp comb to the conical screw.In addition to this, with Berkel Model 9H with Pedestal the machine comb doubles the contact surface and it’s no longer assembled onto the fixing clamp, but on a telescope scrolling headframe. Also, the comb is even inserted in the worm screw at a very high coupling charge. Such special devicen Model Berkel 9H, together with the conical coupling, compensates the comb wear and allows to obtain the best efficiency and life length of such professional slicer.
Upon the headframe a pin pokes out where the clamp is inserted and blocked in. The worm screw and the headframe in this design slicer are covered with a shaped carter, unlike the previous models in which they were immediately visible. It’s about a closed and smooth flywheel slicer.